Section 136 (Cruise Control Systems): Servo: Removal
WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
The speed control servo is attached to a bracket. The bracket and servo assembly are located below the battery tray.
- Disconnect negative battery cable at battery.
- Disconnect positive battery cable at battery.
- Remove air cleaner housing at top of throttle body and disconnect servo cable at throttle body. Refer to Servo Cable Removal/Installation.
- Remove battery from battery tray.
- Disconnect wiring at battery tray.
- Disconnect positive battery cable at Power Distribution Center (PDC).
- Loosen PDC at battery tray.
- Remove 4 battery tray bolts. One of these bolts attaches to speed control bracket flange that supports battery tray. While removing battery tray, disconnect battery temperature sensor electrical connector at sensor.
- Disconnect vacuum line at servo vacuum hose fitting (Fig 1).
- Disconnect electrical connector at servo (Fig 1).
If servo and mounting bracket are being removed as one assembly, remove two mounting nuts (Fig 1). These are located above right-front tire. Remove inner fender clips and pry inner fender back slightly to gain access to mounting nuts.
- If servo is being removed from its mounting bracket, remove 2 mounting nuts holding servo cable sleeve to bracket (Fig 2).
- Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (Fig 2) and remove clip.NOTE:The servo mounting bracket displayed in (Fig 2) is a typical bracket and may/may not be applicable to this model vehicle.
- Remove servo from mounting bracket or, remove servo and mounting bracket as one assembly.