Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Power Seat System) >> Memory Set Switch >> Removal

Memory Set Switch: Removal

WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the trim panel from the driver side front door. Refer to TRIM PANEL for the procedure.
  3. Disconnect the memory switch wire harness connector from the driver door module connector receptacle.
  4. Remove the two screws that secure the memory switch to the back of the driver side front door trim panel.
  5. Remove the memory switch from the back of the driver side front door trim panel.
scientia non olet · About Mike's Workshop Manuals