Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Power Seat System) >> Memory Set Switch >> Installation

Memory Set Switch: Installation

WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the memory switch onto the back of the driver side front door trim panel.
  2. Install and tighten the two screws that secure the memory switch to the back of the driver side front door trim panel. Tighten the screws to 2.2 N.m (20 in. lbs.).
  3. Reconnect the memory switch wire harness connector to the driver door module connector receptacle.
  4. Install the trim panel onto the driver side front door. Refer to TRIM PANEL for the procedure.
  5. Reconnect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals