Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Power Seat System) >> Lumbar Control Switch >> Installation

Lumbar Control Switch: Installation

WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power lumbar switch onto the outboard seat cushion side shield.
  2. Install and tighten the two screws that secure the power lumbar switch to the inside of the outboard seat cushion side shield. Tighten the screws to 1.5 N.m (14 in. lbs.).
  3. Reconnect the power seat wire harness connector to the power lumbar switch connector receptacle.
  4. Position the outboard seat cushion side shield onto the seat cushion frame
  5. Install and tighten the three screws that secure the outboard seat cushion side shield to the seat cushion frame. Tighten the screws to 1.5 N.m (14 in. lbs.).
  6. Reconnect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals