Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2002 >> Grand Cherokee Overland >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Symptom Tests >> Power Door Locks/RKE Systems >> Driver Door Fails To Lock

Driver Door Fails To Lock

Possible Causes are:

  1. Remove the inner door trim panel to gain access to the Driver Door Module C1 connector. Disconnect the Driver Door Module C1 connector. Measure the resistance of the Door Lock Driver circuit in the driver door module C1 connector to body ground. Is the resistance less than 20 ohms? If yes, repair the Driver Door Lock Driver wire for a short to ground. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS. If no, go to next step.
  2. If there are no possible causes remaining, replace the Driver Door Module. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS.
scientia non olet · About Mike's Workshop Manuals