Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2001 >> Cherokee Classic, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Power Steering System) >> Power Steering Pressure Switch >> Installation

Power Steering Pressure Switch: Installation

WARNING: This page is about a different car, the 2002 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

This switch is not used with 4.0L six-cylinder engines.

  1. Install power steering switch into power steering line.
  2. Tighten to 14-22 N.m (124-195 in. lbs.) torque.
  3. Connect electrical connector to switch.
  4. Check power steering fluid and add as necessary.
  5. Start engine and again check power steering fluid. Add fluid if necessary.
scientia non olet · About Mike's Workshop Manuals