Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2000 >> Grand Cherokee Laredo, 4.7 N, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Power Window >> Passenger's Rear Window Inoperative From Rear Switch

Passenger's Rear Window Inoperative From Rear Switch

NOTE: Ensure window lockout switch on DDM (driver's front door switch) is operating properly before proceeding.
  1. Remove passenger's rear door trim panel. Disconnect passenger's rear window switch connector. Using DVOM, measure resistance between ground and passenger's rear window switch connector terminal No. 6 (Black wire). See Figure. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, repair open in Black wire. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  2. Remove passenger's rear window switch. Inspect window switch. Perform continuity check. See PASSENGER'S REAR POWER WINDOW SWITCH CONTINUITY . If continuity is not as specified, replace passenger's rear window switch. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS. If continuity is okay, test is complete.
scientia non olet · About Mike's Workshop Manuals