Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2000 >> Grand Cherokee Laredo, 4.7 N, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Exterior Lighting >> Parking Lights Will Not Turn On

Parking Lights Will Not Turn On

  1. Remove parking light relay from junction block. See Figure. Install a known-good relay in junction block. Operate parking lights. If parking lights do not operate correctly, go to next step. If parking lights operate correctly, replace defective parking light relay. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  2. Using scan tool, select BODY SENSORS. Read HEADLIGHT SW VOLTS. Rotate headlight switch through all positions. Compare with HEADLIGHT SWITCH VOLTAGE SPECIFICATIONS  table. If voltage is within specification, go to next step. If voltage is not within specification, replace left multifunction switch. See appropriate STEERING COLUMN SWITCHES article. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  3. Remove parking light relay from junction block. Disconnect appropriate inoperative parking light connector. Using DVOM, measure resistance of parking light output circuit between parking light relay socket terminal No. 30 and inoperative parking light connector. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, repair open parking light output circuit. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  4. Replace Body Control Module (BCM). See BODY CONTROL MODULE  under REMOVAL & INSTALLATION. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About Mike's Workshop Manuals