Rear Washer, Runs All The Time With Ignition On

Disconnect right multifunction switch connector. See Figure. Remove rear liftgate trim panel. Disconnect rear washer motor connector. See Figure. Turn ignition on. Using DVOM, measure voltage between ground and rear washer pump connector terminal No. 2 (Black/White wire). If voltage is greater than one volt, repair short to voltage in Black/White wire. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS. If voltage is less than one volt, replace right multifunction switch. See appropriate STEERING COLUMN SWITCHES article. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.