Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2000 >> Cherokee Classic, 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Removal & Installation >> Speed Control Servo >> Removal

Speed Control Servo: Removal

  1. Disconnect negative battery cable. Disconnect electrical connector and vacuum hose from servo. Using finger pressure only, push servo cable connector from throttle body bellcrank pin. DO NOT pull cable connector perpendicular to bellcrank.
  2. Remove 2 servo mounting nuts. Pull servo cable sleeve away from mounting bracket to expose cable retaining clip. Remove retaining clip. Remove servo.
scientia non olet · About Mike's Workshop Manuals