Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 1998 >> Grand Cherokee Laredo, 4.0 S, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> System Testing >> Power Door Lock Test 6A - All Doors (Except Left Front Door) Fail To Lock

Power Door Lock Test 6A - All Doors (Except Left Front Door) Fail To Lock

NOTE: Perform POWER DOOR LOCK TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . Refer to DOOR LOCKS - POWER & KEYLESS ENTRY SYSTEM article. After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.

Disconnect passenger's door module 12-pin connector. Using scan tool in ohmmeter mode, measure resistance at terminal No. 6 (Black/White wire) on passenger's door module 12-pin connector. If resistance is more than 20 ohms, repair short to ground in Black/White wire. If resistance is 20 ohms or less, replace passenger's door module.

scientia non olet · About Mike's Workshop Manuals