Test VER-2A (Diesel): Notes

WARNING: This page is about a different car, the 1999 Dodge Pickup and 1999 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If Accelerator Pedal Position Sensor (APPS), battery, Engine Control Module (ECM) or Powertrain Control Module (PCM) has been disconnected or replaced, APPS must be reprogrammed and correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into PCM to prevent Diagnostic Trouble Codes (DTCs) from being set in Anti-Lock Brake System (ABS) module and Supplemental Restraint System (SRS) module. To program PCM and clear DTCs from ABS and SRS modules, proceed to appropriate procedure listed below. On models equipped with a Smart Key Immobilizer Module (SKIM), if replacing Powertrain Control Module (PCM), secret key data must also be updated to enable engine starting. To update secret key data, proceed to appropriate procedure listed below.

CAUTION: DO NOT attempt to adjust screws or disassemble APPS. Settings are preset at factory and are not intended to by changed.

Procedure For Programming APPS Reassemble all components. Turn ignition switch to ON or RUN position without starting engine. Slowly press accelerator pedal to floor once and slowly release. This procedure programs APPS calibration in ECM. Go to FINAL PROCEDURE.

Procedure For Programming PCM & Clearing DTCs From ABS & SRS Modules Connect scan tool to Data Link Connector (DLC). Using scan tool, enter correct VIN and mileage into PCM. Using scan tool manufacturer's instructions, clear DTCs from ABS and SRS modules. Go to FINAL PROCEDURE.

Procedure For Updating Secret Key Data Connect scan tool to Data Link Connector (DLC). Go to ENGINE and then MISC menus on scan tool. Place SKIM in SECURED ACCESS MODE by using appropriate Personal Identification Number (PIN) for this vehicle. PIN may be obtained from owner, vehicle's invoice, or from manufacturer. Select UPDATE THE SECRET KEY DATA. Data will be transferred from Smart Key Immobilizer Module (SKIM) to PCM. Go to FINAL PROCEDURE.