Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 1995 >> Wrangler S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Remove/Install/Overhaul - 4.0L) >> Ignition System >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse removal procedure. Use only proper mounting bolt. Any other replacement bolt will cause improper sensor alignment.
  2. On some Grand Cherokee and Wrangler models with 4.0L engine and automatic transmission, crankshaft position sensor is secured by a single bolt. On models so equipped, ensure paper self-adhesive spacer on end of sensor is replaced if old sensor is being reused. Paper spacer is used to set proper depth. Once engine is started, paper spacer wears away.
scientia non olet · About Mike's Workshop Manuals