Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jaguar >> 2006 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Starting System) >> Starting System (4.2L) >> Start Control Unit - Removal and Installation >> Installation

Start Control Unit - Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the keyless start control module.
    • Connect the electrical connector.
    • Install the Torx screws.
  2. Install the keyless start control module trim cover.
    • Install the Torx screws.
  3. Install the floor console side panel trim.
    • Carefully align and secure the clips.
    • Tighten the Torx screws to 6 Nm (4 lb.ft).
    • Install the opposite hand.
  4. Install the floor console rear panel.
    • Align the lugs and secure the clips.
  5. Install the floor console veneer trim panel. Refer to Floor Console Finish Panel article.
  6. Install the rear seat armrest. Refer to Rear Seat Armrest article.
  7. Connect WDS to the vehicle and configure a new module.
scientia non olet · About Mike's Workshop Manuals