Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jaguar >> 2003 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Speed Control) >> Speed Control (4.2L) >> Speed Control Deactivator Switch - Removal and Installation >> Installation

Speed Control Deactivator Switch - Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During installation of the brake switch, make sure the brake pedal is not depressed at any time. Depressing the pedal may cause: poor operation of the brake light switch and brake lights, diagnostic trouble codes to be logged and/or failure of the vehicle to start.
  1. Install the brake switch.
    • Connect the electrical connector.
    • Secure the clip.
  2. Install the driver's side footwell trim panel.
    • Carefully align and secure the clips.
scientia non olet · About Mike's Workshop Manuals