Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jaguar >> 2003 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Climate Control System - General Information) >> Climate Control System - General Information >> Inspection and Assembly Requirements - General Procedures

Inspection and Assembly Requirements - General Procedures

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Jaguar XKR, 2006 Jaguar XK8, 2005 Jaguar XKR, 2005 Jaguar XK8, and 2004 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for leaks using ultraviolet (UV) Lamp. Refer to Fluorescent Dye Leak Detection - General Procedures .
    2. NOTE: Any time a hose or component connection leak is observed, the component and fitting must be separated, cleaned and a new O-ring fitted and lubricated with air conditioning compressor oil. Refer to Specifications .
    NOTE: When separating A/C joints, cap the open connections immediately. Do not leave open to atmosphere.
  2. O-ring seal surfaces must be free of dirt, lint, burrs and scratches. The O-ring and connector should be lubricated with air conditioning compressor oil. Refer to Specifications .
scientia non olet · About Mike's Workshop Manuals