Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> i-370 4D Pickup, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor 1 Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of #1 Knock Sensor & Engine Oil Pan Rail Engine Wiring Harness Connectors
    GM1352025Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the KS (2) and the retaining bolt to the engine block, positioning the electrical terminals down.

    Tighten:  Tighten the knock sensor (KS) bolt to 25 N.m (18 lb ft).

  2. Connect the engine wiring harness electrical connector to the KS (2).
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals