Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.9L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (4) from the camshaft position (CMP) sensor (5).
    2. Fig 2: View Of Exhaust Camshaft Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor retaining bolt.
  3. Remove the CMP sensor from the cylinder head.

    Discard the O-ring seal.

scientia non olet · About Mike's Workshop Manuals