Installation Procedure

Fig 1: View Of Radio Cables

Courtesy of GENERAL MOTORS CORP.

Position the radio to the I/P.
Connect the electrical connectors to the radio.
Connect the radio antenna cable to the radio.
Position the radio rear alignment locator into the I/P substrate installing the radio to the I/P.

Fig 2: View Of Radio

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 3 screws that retain the radio to the I/P.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
Program the replacement radio. Refer to Control Module References .