Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator & Bolts
    GM1317267Courtesy of GENERAL MOTORS CORP.
  1. Install the generator to the generator bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
    4. Fig 2: View Of Generator B+ Terminal Nut, B+ Lead & Electrical Connector
    GM1317263Courtesy of GENERAL MOTORS CORP.
  4. Install the generator electrical connector.
  5. Install the generator B+ lead.
  6. Install the generator B+ terminal nut.

    Tighten:  Tighten the generator B+ terminal nut to 20 N.m (15 lb ft).

  7. Install the battery ground (negative) cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals