Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0568 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X4 harness connector at the turn signal/multifunction switch.
  2. Ignition ON, verify the scan tool Cruise Set/Coast Switch parameter displays Inactive.
    • If not the specified value, test the signal circuit terminal C for a short to voltage. If the circuit tests normal, replace the ECM.
  3. Install a 3A fused jumper wire between the signal circuit terminal C and the ignition circuit terminal A. Verify the scan tool Cruise Set/Coast Switch parameter displays Active.
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the turn signal/multifunction switch.
scientia non olet · About Mike's Workshop Manuals