Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 325 (Suspension Control System - Automatic Level Control) >> Repair Instructions >> Inflator Air Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Spring Compressor
    GM747617Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the inflator air switch harness from the air compressor.
  3. Lower the vehicle.
  4. Remove the rear quarter lower trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side or to Rear Quarter Trim Panel Replacement - Right Side .
  5. Remove the inflator air switch from the vehicle.
scientia non olet · About Mike's Workshop Manuals