Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Securely attach the mechanics wire already routed behind the I/P to the end of the coaxial cable (3).
- If equipped, carefully remove the rose bud (1) from the coaxial cable.
- Grasp and gently pull the mechanics wire through the cowl insulator, routing the coaxial cable behind the I/P.
- Attach the lower rose bud (2) to the cowl.
- Connect the coaxial cable to the digital radio receiver.
- Attach the coaxial cable to the right windshield pillar (1).
- Install the right front door sill plate. Refer to Front Side Door Sill Plate Replacement .
- Install the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
- Connect the electrical connectors to the digital radio antenna assembly. Refer to Digital Radio Antenna Replacement .
- Install the headliner. Refer to Headlining Trim Panel Replacement .
- Install the right sunshade and inboard retaining clip. Refer to Sunshade Replacement .
- Install the I/P trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
- Install the right windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .