Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radio Antenna Cable To Radio Extension Cable
    GM734416Courtesy of GENERAL MOTORS CORP.
  1. Open the instrument panel (I/P) compartment to a full down position.
  2. Disconnect the radio antenna cable (2) from the radio extension cable.
  3. Remove the lower rear portion of the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front End) .
    4. Fig 2: Identifying Cowl Opening
    GM718019Courtesy of GENERAL MOTORS CORP.
  4. Reach up behind the wheelhouse panel and remove the antenna cable and grommet assembly from the cowl opening (1).
  5. Pass the end of the radio antenna cable assembly through the cowl opening (1).
  6. Remove the antenna mast. Refer to Fixed Antenna Mast Replacement .
  7. Open the hood.
    8. Fig 3: View Of Radio Antenna Cable Assembly
    GM718023Courtesy of GENERAL MOTORS CORP.
  8. Remove the radio antenna cable assembly retaining screws.
  9. Pass the antenna cable and grommet assembly through the fender opening.
  10. Remove the radio antenna cable assembly from the vehicle.
scientia non olet · About Mike's Workshop Manuals