Conditions for Running the DTC

DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0131, P0132, P0137, P0138, P0140, P0141, P0171, P0172, P0201-P0206, P0220, P0300-P0306, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P060D, P060E, P0641, P0651, P1516, P1621, P2A01, P2101, P2120, P2125, P2135, P2138, P2176 are not set.

Passive Test

• The engine is running.
• The Engine Run Time parameter is less than 12 minutes.
• DTC P2A01 runs the passive test once per drive cycle when the above conditions are met.

Intrusive Test

• The Engine Run Time parameter is more than 12 minutes.
• The ignition 1 Signal parameter is between 11-18 volts.
• The Engine Speed parameter is between 1,000-5,000 RPM.
• The Vehicle Speed parameter is between 32-128 km/h (20-80 mph).
• The Short Term FT parameter is between -20 and +20 percent.
• The Air Flow Calculated parameter is between 15-100 g/s.
• The passive test did not pass.
• The maximum number of intrusive attempts is less than 11.
• DTC P2A01 runs the intrusive test once per drive cycle when the above conditions are met for 1 second.