Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Heated Oxygen Sensor 2 Replacement >> Removal Procedure

Removal Procedure

NOTE: Refer to Heated Oxygen Sensor Resistance Learn Reset Notice .
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice .
    Fig 1: Locating Heated Oxygen Sensor Components
    GM729125Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the heated oxygen sensor (HO2S) electrical connector (1).
    3. NOTE: Refer to Excessive Force and Oxygen Sensor Notice .
  3. Remove the HO2S (2) using a J 39194-B  . See Special Tools .
scientia non olet · About Mike's Workshop Manuals