Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft position (CMP) sensor electrical connector (1).
  2. Remove the CMP sensor retaining bolt.
scientia non olet · About Mike's Workshop Manuals