Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 470 (Engine Control System & Fuel System - 4.2L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of (MAP) Sensor & Screw
    GM1922215Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the MAP sensor seal with clean engine oil.
  2. Install the MAP sensor (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAP sensor screw (1).

    Tighten:  Tighten the screw to 9 N.m (80 lb in).

    4. Fig 2: Locating (MAP) Sensor Electrical Connector
    GM1922202Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the MAP sensor.
scientia non olet · About Mike's Workshop Manuals