Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2006 >> i-350 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.5L (L52) - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Intake >> Installation Procedure

Installation Procedure

  1. Lightly lubricate the O-ring seal with clean engine oil.
    2. Fig 1: View Of Intake Camshaft Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  2. Install the intake CMP sensor into the cylinder head.
  3. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CMP sensor bolt threads.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the intake CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    5. Fig 2: View Of Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector to the intake CMP sensor.
scientia non olet · About Mike's Workshop Manuals