Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2006 >> Ascender Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower closeout/insulator panel (GMC only). Refer to Instrument Panel Insulator Panel Replacement (GMC/Chevrolet) .
  2. Remove the accessory trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet) or Instrument Panel Cluster Trim Plate Bezel Replacement (GMC, Buick) or Instrument Panel Accessory Trim Plate Replacement (Buick) or Instrument Panel Accessory Trim Plate Replacement (GMC) .
    3. Fig 1: Identifying Rear Alignment Locator
    GM718020Courtesy of GENERAL MOTORS CORP.
  3. Remove the 3 screws that retain the radio to the instrument panel (I/P).
  4. Partially remove the radio disengaging the radio rear alignment locator (1) to gain access to the electrical connectors.
  5. Disconnect the radio antenna cable.
  6. Disconnect the electrical connectors to the radio.
  7. Remove the radio from the vehicle.
scientia non olet · About Mike's Workshop Manuals