Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2006 >> Ascender Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Digital Radio Receiver Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Connector
    GM1237408Courtesy of GENERAL MOTORS CORP.
  1. Position the receiver near the insulator panel.
  2. Install the antenna electrical connector (1) to the receiver.
    3. Fig 2: Identifying Module Mounting
    GM1237407Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the receiver.
    4. Fig 3: View Of Insulator Panel & Retaining Nuts
    GM1236121Courtesy of GENERAL MOTORS CORP.
  4. Install the receiver to the insulator panel.
    5. NOTE: Refer to Fastener Notice .
  5. Install the nuts retaining the receiver to the insulator panel.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  6. Install the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About Mike's Workshop Manuals