Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2006 >> Ascender Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radio Antenna Cable Assembly
    GM718023Courtesy of GENERAL MOTORS CORP.
  1. Install the radio antenna cable assembly to the vehicle.
  2. Pass the antenna cable and grommet assembly through the fender opening.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the radio antenna cable assembly retaining screws.

    Tighten:  Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).

  4. Close the hood.
  5. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
    6. Fig 2: Identifying Cowl Opening
    GM718019Courtesy of GENERAL MOTORS CORP.
  6. Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
  7. Install the antenna cable grommet assembly to the cowl opening.
  8. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front End) .
    9. Fig 3: View Of Radio Antenna Cable To Radio Extension Cable
    GM734416Courtesy of GENERAL MOTORS CORP.
  9. Install the radio antenna cable (2) to the radio extension cable.
  10. Close the I/P compartment.
scientia non olet · About Mike's Workshop Manuals