Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2006 >> Ascender Limited, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the MAP sensor electrical connector (3).
    2. Fig 2: MAP Sensor
    GM1509706Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor retaining clip (2) from the intake manifold.
  3. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About Mike's Workshop Manuals