Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2005 >> Ascender Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.2L - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV)  or Fuel Tank Replacement (TrailBlazer, Envoy, Rainier) .
  2. Disconnect the fuel tank pressure harness connector.
    3. Fig 1: Locating Fuel Tank Pressure Sensor
    GM1480291Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel tank pressure sensor.
scientia non olet · About Mike's Workshop Manuals