Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2004 >> Axiom Base, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Major Components (3) >> Disassembly, Inspection and Reassembly of Minor Components >> General Assembly

General Assembly

  1. All oil seal rings, clutch discs, clutch plates, rotating parts, and sliding surfaces should be coated with transmission fluid prior to reassembly.
  2. All gaskets and rubber O-ring should be replaced.
  3. Make sure that the ends of a snap ring are not aligned with one of the cutouts and are installed in the groove correctly.
  4. If a worn bushing is to be replaced, the subassembly containing that bushing must be replaced.
  5. Check thrust bearings and races for wear or damage. Replace if necessary.
  6. Use petroleum jelly or vaseline to keep parts in place.
scientia non olet · About Mike's Workshop Manuals