Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2004 >> Ascender S, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls (Introduction) - 5.3L) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank Pressure Sensor Electrical Connector
    GM899743Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Close the retaining clip.
  3. Connect the fuel tank pressure sensor electrical connector (3).
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals