Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2004 >> Ascender S, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) - 4.2L >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the crankshaft position (CKP) sensor harness connector.
    3. Fig 1: View Of Crankshaft Position Sensor
    GM1237427Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor retaining bolt.
  4. Remove the CKP sensor from the engine block.
scientia non olet · About Mike's Workshop Manuals