Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2004 >> Ascender LS, 5.3 P, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) - 5.3L >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the CKP sensor.
  2. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
  4. Install the starter. Refer to Starter Motor Replacement (4.2L Engine) or Starter Motor Replacement (5.3L Engine) in Engine Electrical.
scientia non olet · About Mike's Workshop Manuals