Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2003 >> Axiom Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (HVAC Systems) >> Receiver / Drier >> Receiver / Drier And Associated Parts >> Installation

Receiver / Drier And Associated Parts: Installation

WARNING: This page is about a different car, the 2002 Isuzu Axiom. However, it is still accessible from the selected car via links, so may be relevant.

To install, follow the removal steps in the reverse order, noting the following points:

  1. If installing a new receiver/drier, be sure to add 30cc (1.0 fl. oz.) of new compressor oil to a new one.
  2. Put the receiver/drier in the bracket and connect with the refrigerant line. Check that no excessive force is imposed on the line. Fasten the bracket bolt to the receiver/drier.
  3. Tighten the refrigerant line to the specified torque.

    Torque:  6 N.m (52 lb in)

  4. O-rings cannot be reused. Always replace with new ones.
  5. Be sure to apply new compressor oil to the O-rings when connecting the refrigerant line.
scientia non olet · About Mike's Workshop Manuals