Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2003 >> Ascender 4.2 S, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Lighting Systems) >> Repair Instructions >> Stop Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Isuzu Ascender. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Brake Light Switch
    GM748017Courtesy of GENERAL MOTORS CORP.
  1. Install the electrical connector to the stop lamp switch (1).
  2. Position the stop lamp switch (1) on the pushrod (2) and install the assembly on the brake pedal pin.
  3. Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place.
  4. Install the left sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About Mike's Workshop Manuals