Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 2002 >> Rodeo Sport 2.2 D, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Power-Assisted Steering System) >> Power Steering Unit >> Installation (4X4 Model)

Installation (4X4 Model)

WARNING: This page is about a different car, the 2002 Isuzu Rodeo and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install power steering unit to crossmember. Tighten fixing bolt to specified torque.

    Torque:  116 N.m (85 lb ft)

  2. Install power steering unit with crossmember to frame by aligning the setting marks made when removing. Tighten crossmember mounting bolt to specified torque.

    Torque:  173 N.m (128 lb ft)

  3. Install lower control arm bolt. Refer to LOWER CONTROL ARM .
  4. Install torsion bar. Refer to TORSION BAR .
  5. Connect the feed line and return line.

    Torque:  25 N.m (18 lb ft)

  6. Install tie-rod end assembly to knuckle.

    Torque:  118 N.m (87 lb ft)

    1. Align the setting marks made at removal. Install the universal joint assembly to the transfer gear assembly.

      Temporary tighten the universal joint bolt.

    2. Install the universal joint assembly to the power steering unit assembly.

      Temporary tighten the universal joint bolt.

    3. Install the transfer gear assembly with the shim to frame.

      Torque:  54 N.m (40 lb ft)

    4. Tighten the universal joint bolt to the specified torque.

      Torque:  31 N.m (23 lb ft)

  8. Install the stone guard.
  9. Bleed the system. Refer to BLEEDING THE POWER STEERING SYSTEM  .
scientia non olet · About Mike's Workshop Manuals