Insight (Front & Rear)
WARNING: This page is about a different car, the 2002 Honda Odyssey, 2002 Honda Civic, 2002 Honda CR-V, and 2002 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
- Secure steering wheel in straight ahead position. Check rear wheel toe-in. See WHEEL ALIGNMENT SPECIFICATIONS . If rear toe-in is not within specification, check for bent or damaged suspension components. Replace faulty components. Recheck rear toe-in.
- Measure front toe-in. See WHEEL ALIGNMENT SPECIFICATIONS . If adjustment is needed, loosen inner tie rod lock nut, then loosen outer tie rod lock nut while holding tie rod end. See Fig 1 .
- Loosen the inner lock nut while holding the tie-rod arm, and loosen the outer lock nut while holding the tie-rod end. Turn the adjusting bolt until the toe is correct. After adjusting, tighten the lock nuts while holding the tie-rod arm or tie-rod end. Make sure the arrow on the tie-rod arm and the aligning mark on the tie-rod end are in line, viewing from the wheelhouse side along the axial direction of the tie-rod, on both right and left side of the vehicle making sure the toe setting does not change. See Fig 1 .