Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Isuzu >> 1982 >> Pickup 2.2L Eng VIN S, RWD, Automatic Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> Wheel Alignment (Procedures) >> Adjustment >> Caster >> All Other Models

All Other Models

  1. To set caster, realign the washers located between legs of upper control arm. One 1/8" (3 mm) thickness washer and one 3/8" (9 mm) thickness washer must be used as a couple for caster adjustment.
  2. The combination that the total thickness of front and rear equals is 1/2" (12 mm). Only minimal changes to caster can be accomplished this way.
scientia non olet · About Mike's Workshop Manuals