Work Procedure
Always perform the Intelligent Drive Alertness (I-DA) system action test to check that the system operates normally after replacing the around view monitor control unit or repairing any Intelligent Drive Alertness (I-DA) system malfunction.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- System description for I-DA: Refer to System Description .
- Handling precaution: Refer to Handling Precaution .
- CHECK I-DA SYSTEM SETTING
- Start the engine.
- After start the engine wait for 30 seconds or more.
- Check that the Intelligent Drive Alertness (I-DA) system setting can be enabled/disabled through the vehicle information display.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
>>
GO TO 2.
- ACTION TEST FOR INTELLIGENT DRIVE ALERTNESS (I-DA)
- Enable the setting of the Intelligent Drive Alertness (I-DA) system through the vehicle information display.
- Check the I-DA operation according to the following table.
Vehicle condition/ Driver's operation Display on combination meter I-DA OFF - I-DA ON
>>
Inspection End