DTC Confirmation Procedure

1. If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2 .

1. CONSULT
   1. Start the engine.
      CAUTION:

      Never drive the vehicle.

   2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC "C1607-01" or "C1608-01" detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.