DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms(Trouble diagnosis content) | DTC detection condition | ||
| P0010 | 00 | A camshaft position actuator B1("A" camshaft position actuator control circuit/open bank 1) | Diagnosis condition | Ignition switch ONMotor relay ON |
| Signal (terminal) | Electric intake valve timing (IVT) control module power supply | |||
| Threshold | The electric intake valve timing control module detects internal power stage malfunction | |||
| Diagnosis delay time | 1 second or more | |||
POSSIBLE CAUSE
- Electric intake valve timing (IVT) control module power supply
FAIL-SAFE
Not applicable
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Check 1st trip DTC.
Is 1st trip DTC detected?
>>
Proceed to Diagnosis Procedure .
>>
To check malfunction symptom before repair: Refer to Intermittent Incident
>>
Confirmation after repair: INSPECTION END