| U0428: ST ANGLE SENSOR CALIBRATION |
Neutral position adjustment of steering angle sensor is not complete. |
Predicted course line is not displayed. |
| U1000: CAN COMM CIRCUIT |
When around view monitor control unit cannot transmit/receive CAN communication signal continuously for 2 seconds or more. |
The following functions are stopped
- When communication of steering angle sensor signal is not normal:
- Predicted course line is not displayed.
- MOD (Moving Object Detection) function is stopped.
- When communication of wheel speed sensor signal and shift signal is not normal:
- Predicted course line is not displayed.
- MOD (Moving Object Detection) function is stopped.
- When communication of sonar control unit is not normal:
- Sonar indicator is displayed in red.
|
| U111A: REAR CAMERA IMAGE SIGNAL |
No-signal status of rear camera image signal is continued for 500 ms or more while ignition switch is ON. |
Camera image is not displayed (gray screen display). |
| U111B: SIDE CAMERA RH IMAGE SIGNAL |
No-signal status of side camera RH image signal is continued for 500 ms or more while ignition switch is ON. |
| U111C: FRONT CAMERA IMAGE SIGNAL |
No-signal status of front camera image signal is continued for 500 ms or more while ignition switch is ON. |
| U111D: SIDE CAMERA LH IMAGE SIGNAL |
No-signal status of side camera LH image signal is continued for 500 ms or more while ignition switch is ON. |
| U1232: ST ANGLE SEN CALIB |
Neutral position adjustment of steering angle sensor is performed. NG signal from steering angle sensor is received. |
Predicted course line is not displayed. |
| U1302: CAMERA POWER VOLT |
Camera power supply voltage does not satisfy the following conditions for 2 seconds or more when ignition switch is turned ON:
- When supplemental lighting power supply output is ON: 5.9 - 6.5 V.
- When OFF: 0 V by camera power supply measurement.
|
Camera power output is stopped. |
| U1304: CAMERA IMAGE CALIB |
- When camera calibration is incomplete.
- When camera information in around view monitor control unit and information read from camera are not the same.
|
Unmatched icon 
display (red) is displayed (applicable for unmatched camera only). |
| U1305: CONFIG UNFINISH |
The vehicle setting of around view monitor control unit is incomplete. |
Operation is according to the vehicle setting value as default value. |