Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect steering angle sub motor harness connector.
3. Check the continuity between motor connector terminals.

   Steering angle sub motor		Continuity
   Terminal
   1	2	Existed
   1	3	Existed
   1	4	Not existed
   2	3	Existed
   2	4	Not existed
   3	4	Not existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Steering angle sub motor is malfunction. Replace steering gear assembly. Refer to STEERING GEAR AND LINKAGE : Removal and Installation .