DTC Diagnosis Procedure

Perform configuration for each control module. Refer to Work Procedure (EPS/DAST 3), or Work Procedure (DAST 1), or Work Procedure (DAST 2).

>>

GO TO 2.

With CONSULT

1. Turn the ignition switch ON.
2. Erase self-diagnosis for "DAST 2".
3. Turn the ignition switch OFF and wait for at least 10 seconds.
4. Start engine.
   CAUTION:

   Never drive the vehicle.

5. Perform self-diagnosis for "DAST 2".

Is DTC "C13EE-00" detected?

YES>>

Replace steering angle sub control module. Refer to STEERING ANGLE SUB CONTROL MODULE : Removal and Installation .

NO>>

INSPECTION END