DTC Diagnosis Procedure

With CONSULT

1. Start the engine.
   CAUTION:

   Never drive the vehicle.

2. On the CONSULT screen, select "DAST 1">>"DATA MONITOR">>"C/M TEMPERATURE".
3. Wait with the ignition switch OFF until the data monitor indication becomes between -40°C (-40°F) and 150°C (302°F).

Does the temperature become between -40°C (-40°F) and 150°C (302°F)?

YES>>

GO TO 2.

NO>>

Replace steering angle main control module. Refer to STEERING ANGLE MAIN CONTROL MODULE : Removal and Installation .

With CONSULT

1. Turn the ignition switch ON.
2. Erase self-diagnosis for "DAST 1".
3. Turn the ignition switch OFF and wait for at least 10 seconds.
4. Start the engine.
   CAUTION:

   Never drive the vehicle.

5. Perform self-diagnosis for "DAST 1".

Is DTC "C13DE-00" detected?

YES>>

Replace steering angle main control module. Refer to STEERING ANGLE MAIN CONTROL MODULE : Removal and Installation .

NO>>

• Check enlarged contact spring of terminal. Refer to Inspection .
• Perform intermittent incident while turning steering wheel. Refer to Inspection .